In order to get the correct replacement jewel for your watch we need the following dimensions:

Hole / Balance Jewel  Cap Jewel

For hole & balance jewels we need (all measurements must be to the nearest 1/100th mm):

A: Overall diameter of jewel (in mm or inches).

B: Diameter of setting.

C: Pivot size.

D: (Not shown) The thickness of the setting.

For Cap Jewels we need (all measurements must be to the nearest 1/100th mm):

F: Overall diameter of the setting (in mm or inches)

G: Thickness of the jewel setting.

Due to the difference in manufacturing processes using the factory part number is not always sufficient (trust me on this).  I do not inventory jewels by the factory part number for this reason.  Unfortunately, I will not be able to supply any replacement jewels without these dimensions even if the movement info is known.